|
Post by metalcaster2 on Jan 19, 2015 20:30:34 GMT -8
So far I'm not getting sub MOA groups with any bullets less than 70 grain and with these I get .3 groups. Have tried 8208,H335, Benchmark, Tac, H4895,and Varget. Just found some AA2200 and will try a ladder using that. Any ideas will be appreciated. All loads are 2.260max length. Thanks,
|
|
|
Post by GLSHOOTER on Jan 20, 2015 9:26:46 GMT -8
So far I'm not getting sub MOA groups with any bullets less than 70 grain and with these I get .3 groups. Have tried 8208,H335, Benchmark, Tac, H4895,and Varget. Just found some AA2200 and will try a ladder using that. Any ideas will be appreciated. All loads are 2.260max length. Thanks, I use: 65 VMAX H4895 28 grains at 2.255--- 3221 FPS 58 VMAX H335 28 grains at 2.255--- 3298 FPS Both sub-MOA with more room to go for MAX Greg
|
|
|
Post by metalcaster2 on Jan 20, 2015 16:50:36 GMT -8
Thanks Greg. Will try these loads and report back. Any good AA2200 loads and 55 gr NBT? That is my preferred bullet for coyotes in my 223 AI
|
|
|
Post by GLSHOOTER on Jan 20, 2015 18:36:35 GMT -8
Thanks Greg. Will try these loads and report back. Any good AA2200 loads and 55 gr NBT? That is my preferred bullet for coyotes in my 223 AI If you mean 6X45 I'll look at my regular rifle loads. If you mean 223 I'll do some digging. Greg
|
|
|
Post by metalcaster2 on Jan 21, 2015 7:17:04 GMT -8
Would like the 6 x 45 data for the 55 gr NBT. I like this bullet better than the vmax profile. Only loads that have indicated pressure were with Benchmark and 75 gr at max published data. Which primers do you recommend. I run CCI 450 and WSR on all loads to compare groups and chrono results. Thanks, Fred
|
|
|
Post by GLSHOOTER on Jan 21, 2015 16:24:31 GMT -8
Would like the 6 x 45 data for the 55 gr NBT. I like this bullet better than the vmax profile. Only loads that have indicated pressure were with Benchmark and 75 gr at max published data. Which primers do you recommend. I run CCI 450 and WSR on all loads to compare groups and chrono results. Thanks, Fred My go to load on those is AA 2460 at 28.5 grains. I use Remington 7 1/2's or CCI 450's. They are death on PD's. Greg
|
|