|
Post by GLSHOOTER on Nov 21, 2016 13:04:57 GMT -8
Bump it another 0.001
Greg
|
|
|
Post by zr600 on Nov 21, 2016 13:19:43 GMT -8
.001 more didn't help chamber good but won't eject with out tapping the buttstock
|
|
|
Post by GLSHOOTER on Nov 21, 2016 14:02:17 GMT -8
Maybe Ritch has an idea. Did you work over the extractor?
Greg
|
|
|
Post by zr600 on Nov 21, 2016 15:58:33 GMT -8
I talked to ritch got it figured out don't think my brass is getting sized enough. Because some will eject and some won't. I'm going to do the stuff recommended to the extractor and ejector. Also I'm going to grind off my shell holder because the die is hitting it and hopefully that will clear it up.
|
|
|
Post by zr600 on Nov 23, 2016 18:35:31 GMT -8
Ok I have feed some rounds unloaded into my gun and just softly close the bolt push the forward assist forward to make sure it closed all the way. And ejected them with the charging handle. Now technically if they will chamber this way and eject this way the gun should run correct? Just want to make sure might get out hunting this weekend and want to make sure it runs without problems. Thanks again for all the help Ritch and GLshooter.
|
|
|
Post by GLSHOOTER on Nov 23, 2016 19:57:51 GMT -8
Ok I have feed some rounds unloaded into my gun and just softly close the bolt push the forward assist forward to make sure it closed all the way. And ejected them with the charging handle. Now technically if they will chamber this way and eject this way the gun should run correct? Just want to make sure might get out hunting this weekend and want to make sure it runs without problems. Thanks again for all the help Ritch and GLshooter. If you've never shot it before there are no guarantees. The gas system has to be adequate but if the cartridges go in and out you are 90% there. The rest is magazines and gas. Greg
|
|
|
Post by zr600 on Nov 23, 2016 20:53:04 GMT -8
Yes it has been shot before. So I believe I should be good to go. I'll post my results on Friday.
|
|