|
Post by ChiefPlumber on Apr 15, 2017 16:32:31 GMT -8
...but a lot of you folks are wildcatters. I'm looking for brass for a 7mm BR. Yeh, it can be formed from 6mm BR, but, occasionally somebody let's go of some 7mm...or has a supplier.
Regards, CP
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 16, 2017 3:22:59 GMT -8
...but a lot of you folks are wildcatters. I'm looking for brass for a 7mm BR. Yeh, it can be formed from 6mm BR, but, occasionally somebody let's go of some 7mm...or has a supplier. Regards, CP I haven't seen any 7mm brass in years. If you do find some it will most likely be Remington. It's so simple to make, I would just buy Lapua and open the necks. You will end up with more consistent brass when your through. It will also have the small flash hole. IMHO Lapua is worth the time and expense it will take to make 7mm brass. It will also hold up to more loadings than Remington brass.
|
|