|
Post by l3outdoorsstx on Sept 27, 2017 15:59:40 GMT -8
I need to load up some Lehigh Defense 60gr to test and I need a starting point. The powders I have on hand are Benchmark, 8208, Re15, CFE223, Varget,
|
|
|
Post by GLSHOOTER on Sept 27, 2017 16:50:35 GMT -8
I'll look around tomorrow but anything 58 in the 6X6.8 backed down a half grain should work.
Greg
|
|
|
Post by l3outdoorsstx on Sept 27, 2017 17:09:26 GMT -8
Thanks GL.
|
|
|
Post by l3outdoorsstx on Sept 27, 2017 18:15:16 GMT -8
I did the usually and looked up 6mm PPC data and 6mmBR data but it is conflicting. In the past when I have found the data conflicting like that it leaned towards the 6mm PPC side and the start loads for 6mmBR where to hot.
|
|
|
Post by GLSHOOTER on Sept 27, 2017 18:44:32 GMT -8
I did the usually and looked up 6mm PPCe data and 6mmBR data but it is conflicting. In the past when I have found the data conflicting like that it leaned towards the 6mm PPC side and the start loads for 6mmBR where to hot. Depending on the book and the powder you will see that. 6PPC top loads will always be safe. Greg
|
|
|
Post by GLSHOOTER on Sept 28, 2017 15:30:47 GMT -8
I've never tried a Lehigh bullet so I'll be cautious. I've never shot a 60 so these are WAG at extrapolations from 58's. A smart man might go down 0.5 grains on these or at minimum 0.3.
RL 15 31.2 8208 31.5 CFE 223 33.0 BM 32.5
I have not a clue on VARGET
Greg
|
|