|
|
Post by ralphob on Nov 21, 2012 11:04:51 GMT -8
I am thinking about using a full length bushing sizer die for my 264lbc. The necks of my loaded cases using hornady brass are measuring approx .291. Would that mean that I should be using a .288-.289 bushing? Any help would be appreciated.
|
|
|
|
Post by GLSHOOTER on Nov 21, 2012 11:59:57 GMT -8
I am thinking about using a full length bushing sizer die for my 264lbc. The necks of my loaded cases using hornady brass are measuring approx .291. Would that mean that I should be using a .288-.289 bushing? Any help would be appreciated. That would be just right. Anything over about 0.005 less is not good. Most of us are running 0.002 below loaded neck size. Greg |
|
