|
|
Post by joebush on Dec 1, 2012 4:15:10 GMT -8
Would I be correct that 6x6.8 has the same case length dimensions as 6.8spc? Would it be practical to get a case length gauge from Lee for 6.8 SPC and turn it down to 6mm? I have access to a lathe and do not feel that this would be a very complicated process.
Joe
|
|
|
|
Post by GLSHOOTER on Dec 1, 2012 7:25:55 GMT -8
Would I be correct that 6x6.8 has the same case length dimensions as 6.8spc? Would it be practical to get a case length gauge from Lee for 6.8 SPC and turn it down to 6mm? I have access to a lathe and do not feel that this would be a very complicated process. Joe THey are the same. If you have the goodies why not. I prefer the Hornady set up but nothing wrong if it gives you workable numbers in going a different route. Greg |
|
