|
|
Post by geepee3 on Oct 25, 2015 18:47:15 GMT -8
What type of set up/modification, if any, to a 6.8 SPC bullet seating die to convert it to seat .257" bullets.
It looks like on some dies you can change out the .277" bullet seating stem with a .257" bullet seating stem.
I ask because I did not see anything for 25x6.8 on CH4D's web site.
Glenn
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Oct 25, 2015 19:18:09 GMT -8
|
|
|
|
Post by geepee3 on Oct 25, 2015 19:27:34 GMT -8
Thank you Sir.
That die with a Hornady microjust seating stem should work out fine for me.
Thanks again for the quick response.
Glenn
|
|
|
|
Post by BiggerHammer on Oct 31, 2015 8:17:56 GMT -8
Just give CH4D a call. Beth will hook you up, they have a wide selection of dies that are not listed on their site and Beth knows where it's all at. She has been great with helping me out with my die needs.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Oct 31, 2015 13:08:23 GMT -8
Don't worry about calling CH4D for 25x6.8 dies. To my knowledge they have yet to ever make a set of them.
Take it from somebody that has been there and done that. Go with the Hornady die and add a micrometer top.
|
|
|
|
Post by geepee3 on Oct 31, 2015 13:55:45 GMT -8
Thanks guys for the input. The question was posed more for investigative reasons.
To be honest, I'm not sure which 6.8 SPC variant I want to do.
I just may do a straight 6.8 SPC.
Still doing my homework on this next upper build.
Thanks again,
Glenn
|
|
