|
Post by knightmare on Mar 8, 2016 10:29:54 GMT -8
Ordered my barrel last week and have been looking at flash hiders. I believe the tpi to be 1/2-28, is the ID of the bore large enough to pass a 6mm bullet on a standard 1/2-28 FH? Looking around I only see a couple of 7.62 bore FH's with 1/2-28 threads. Would just like to know if I need the 7.62 bore, or need to drill out a 5.56 or settle for one of the two I found, TIA
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 8, 2016 16:54:01 GMT -8
Ordered my barrel last week and have been looking at flash hiders. I believe the tpi to be 1/2-28, is the ID of the bore large enough to pass a 6mm bullet on a standard 1/2-28 FH? Looking around I only see a couple of 7.62 bore FH's with 1/2-28 threads. Would just like to know if I need the 7.62 bore, or need to drill out a 5.56 or settle for one of the two I found, TIA Most flash hiders are already drilled big enough for a 6mm bullet to pass through without any problems. Just order the one you want and check it when you get it. They are easy to drill if needed. A simple hand drill and bit will make short work of the task.
|
|